DESCRIPTION
Ideal medical-orthopedic support for stabilizing the cervical tract.
The frame is designed to be comfortable and well-ventilated to ensure optimal immobilization and well-being. The soft foam covering minimizes pressure points, increasing patient comfort.

CHARACTERISTICS
• Thermoplastic material structure.
• Nylon/polyester covering coupled with polyurethane foam.
• Side clip closures.

INTENDED USE
Non-invasive therapeutic medical devices designed to correct postural problems.

DIRECTIONS
ALS
rats
neurological pathologies
cervical spine distortions (whiplash)
stiff neck
disc disease
metastatic collapse
cervical arthrosis
vertigo crisis of cervical origin
post-operative
useful in case of tracheotomy.

APPLICATION
Preparation of the Orthosis:
1. Remove the rear valve by pressing the buttons on the locking disc. Lift the disc. Repeat on the other side.
2.Loosen the back panel straps using the button on the back of the locking disc and slide it towards the end of the strap.
3. Press the buttons on the front of the chin guard and position it appropriately.

Application:
1.With the patient lying down and the head in a neutral position, slide the posterior valve under the patient's neck.
Place the back shell with the straps between the ear and the top of the shoulder.
2.Apply the anterior valve to the patient's neck until it reaches the desired position.
3.Holding the bottom of the shell, press the buttons on the chin rest and gently lift it to the desired position so that the patient's chin rests on the foam liner.
4. Snap the locking discs on both sides
5.Hold the front panel with one hand and pull each strap forward to adjust the circumference size until the back panel fits comfortably against the back of your neck.

Application in a sitting position:
1. Remove the rear shell using the buttons on the locking disc. Lift the front shell. Repeat on the other side.
2.Loosen the rear valve straps using the button on the back of the locking disc and slide this towards the end of the strap.
3. Press the buttons located on the front of the valve and choose the most suitable position.

Application:
1. With the patient seated and their head in a neutral position, slide the front portion over the patient's neck. Secure the rear shell to the front shell by snapping the locking disk onto the opposite side.
2.Holding the lower part of the valve, press the buttons on the chin rest and gently lift to the desired position so that the patient's chin rests on the foam liner.
3. Hold the chin strap with one hand and pull each strap forward to adjust the circumference size until the rear valve fits comfortably against the back of your neck.

SIZES
Unique



barcode: 8133976192423
code: TO0304