It is a medical-orthopedic support designed to ensure maximum support, encouraging the body to maintain correct posture during movement. Thanks to its structure and
study carried out on elastic straps, it adheres to the body perfectly, providing a pleasant sense of security and well-being while remaining aesthetically pleasing and not too bulky.
visible.

CHARACTERISTICS
• Cotton and Lycra blend fabric.
• Front Velcro closure.
• Elastic traction straps with padded shoulder straps.
• Lumbar area supported by moldable stays integrated into the band.
• Abdominal area with oblique spiral reinforcement.
• Front height 22 cm, rear 55 cm.

INTENDED USE
Non-invasive therapeutic medical devices designed to correct postural problems.

DIRECTIONS
Back pain due to arthritic or kyphotic causes
vertebral fractures
upper dorsal and lumbar muscles and their outcomes
vertebral collapses
dorsal on an osteoporotic or metastatic basis.

APPLICATION
Do not wear the brace next to your skin.
1. Loosen the torso straps by temporarily fastening them to the slanted lateral Velcro strips.
2. Put on the corset and fasten it well with the Velcro fastening
central, taking care to check that the thumb loop is positioned upwards.
3. Tighten the torso by first using the two lower straps, anchoring them well to the central front Velcro, after having detached them from the lateral oblique Velcro strip. Repeat.
the operation for the two high tie rods.
4. Pass the shoulder straps over the shoulders, then under the armpits, cross them at the back by sliding them inside the loop and finally fasten them
on the front central Velcro.
5.For correct positioning, make sure that the lower back edge of the corset is positioned approximately halfway up the buttocks.

SIZES
XS = hip circumference 73/83cm
S = hip circumference 83/93cm
M = hip circumference 93/103cm
L = hip circumference 103/113cm
XL = hip circumference 113/123cm
XXL = hip circumference 123/133cm
XXXL = hip circumference 133/143cm



barcode: 8033976194161
code: TO1202-XXXL